
Product Overview
Zhimeitang ML80 is a modified starch made from Southeast Asian plant starch through gelatinization and drying.
Main ingredients	Dry dextrin
additive	none

Technical requirements

Appearance	Free-flowing, white powder
Fineness	80 mesh pass rate ≥ 92%
Moisture content	≤12.0%
ash content	≤0.5%
pH	6～8

Application

821 putty, quick-drying powder, and gypsum mortar.

Main application areas

- Especially suitable for neutral interior wall putty.

Main performance

-Good adhesion, non-toxic and odorless, green and environmentally friendly

Use in Putty

- Small dosage, low cost
-Good bonding performance and high putty strength
-Stable performance

Mixing of ML80

Zhimeitang ML80 can be mixed with other dry materials in commercially available mixing equipment to produce powdered products, but it must be fully mixed. When mixing a powdered product, typically fill a suitable container with the required amount of mixing water and then add the powdered dry mix while stirring. Excessive stirring can introduce excess air bubbles. For best results, let the mixture sit for 3 to 5 minutes before stirring again.

Packaging and storage

Standard packaging : 25kg paper bag lined with polyethylene film bag
Other types of packaging are also available upon special request

As a general rule, it is recommended that the ML80 be stored in a cool, dry, and well-ventilated place indoors and used within 6 months. If the packaging bag is stacked under pressure, damaged, or opened for too long, it may cause caking.

Quality, safety and environmental protection

This product is not a hazardous chemical. All users are advised to read the product safety instructions carefully.

Product Liability

The above information and suggestions are based on our experience and are for reference only. They do not replace the customer's own experiments. Since Zhimeitang cannot control the transportation, storage, handling, and use conditions of the products after they are sold, any quality accidents or financial disputes caused by improper use cannot be attributed to the advice we provide. In any application, the customer shall assume the obligation to comply with the intellectual property rights of third parties.

Technical information may not be provided to third parties without our consent.